4/23/2024 0 Comments 2017 yamaha r6 ecu flash![]() ![]() ![]() But it would change from 170’ish degrees at cold, to -40 when at about 180 Degrees F. ![]() This value would change when the bike was getting hotter. I tested this by connecting the white analog cable from a channel to this GW wire and ran the bike. One of them is the GW wire that is the readout from the ECU for Water Temp. In the YEC harness, at the gauge connection, there is a 4-pin connector that is empty. I just need to find locally a 2000 ohm resistor and Terminal Block to test it. Just to give full transparency, I haven't actually tried to connect the ECU to the dash.įor the water temp sensor, I think I figured out the wiring needed. I was fine as i have the large H20 radiator now so i was more worried about being too cold!ĪIM is still telling me that there is no timetable on when their drivers will be updated to allow the FlashTune ECU to be compatible. So after racing for the weekend (couple weeks ago), i used a IR gun to check temps and make sure all was ok. Thats fine, but if anyone has more info on this that would be greatly appreciated.Īll of my other data works and reads out fine, just not the ECU feed. Question 2: Has anyone hardwired a channel to the Water Temp sensor? If so, can anyone give some insight here? AIM says i'll need a pull-up resistor. The only other reading i need now is from Water Temp, as I can use the GPS for speed. I believe everything else is going to need to be hardwired as well. Now, because of all of this, i got the RPM hardwired now to the coil, so thats is solved for now. Question 1: Has anyone set up the MXS1.2 on a 2016 and older R6? AIM tells me that the ECU needs to be OEM or YEC.ĪIM says if i use a YEC ECU i can use the MXS dash but i will have to keep my stock dash connected to the harness and jump the K-line feed from the OEM dash to the MXS. I call AIM yesterday and they tell me that the MXS1.2 doesn't work with FlashTune, not matter if FlashTune enabled ECU access on their end. I have everything setup in Race Studio 3 correctly according to AIM. I have had Flash Tune enable the AIM data in the ECU but i still can't get the reading of RPM, Water Temp, Etc, that the ECU is suppose to read to AIM. Now, I have the Race Team Package from Flash Tune and have it running on that. Long story short, i got rid of that system and got the MXS1.2 dash data logger. Long story short, I had the EVO4 with the G-Dash originally and could never get it working. Im having difficulty with this data logging thing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |